Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
Airbag Warning Light: Testing and Inspection
Warning Light Indicates DTC, Then Normal Code (Test #2)
DIAGNOSIS:
-
Airbag connector is faulty.
-
Fuse No.11 (in joint box) is blown.
-
Airbag main harness is faulty.
-
Airbag control module is faulty.
-
Body harness is faulty.
CAUTION: Before performing diagnostics on airbag system, turn ignition switch "OFF", disconnect battery ground cable, and then wait at least 20
seconds.
5AC1: AIRBAG CONNECTOR APPEARANCE INSPECTION
Conduct appearance inspection on airbag connectors (AB2) through (AB26).
NOTE:
Check terminals, case and wiring harnesses for damage.
CHECK: Is there anything unusual about the appearance of connectors (AB2) through (AB26)?
YES:
Replace faulty airbag component parts.
NO:
Go to step
5AC2.
5AC2: AIRBAG CONNECTOR VIBRATION INSPECTION
Conduct vibration inspection on airbag connectors (AB2) through (AB26).
NOTE: Gently shake each airbag connector.
CHECK: Do the connectors (AB2) through (AB26) malfunction again when shaking?
YES:
Replace faulty airbag component parts.
NO:
Go to step
5AC3.
5AC3: SHOWERING INSPECTION TO BODY
Spray water on vehicle body.
CAUTION: Do not directly spray water on airbag components.
NOTE: If leaks are noted, also check wiring harnesses as water may leak along them and wet airbag connectors.
CHECK: Does water leak into the passenger compartment when showering vehicle?
YES:
Replace faulty airbag component parts.
NO:
Go to step
5AC4.
5AC4: FUSE NO.11 (IN JOINT BOX), AIR-BAG MAIN HARNESS, AIRBAG CONTROL MODULE, BODY HARNESS APPEARANCE
INSPECTION
Conduct appearance inspection on fuse No.11, airbag main harness, airbag control module and body harness.
NOTE: Also check connectors, terminals, wiring harness and case for damage.
