Legacy Outback Ltd Sedan AWD F4-2.5L SOHC (2001)
CAUTION: Be careful not to strike ABS sensor's pole piece and tone wheel's teeth against adjacent metal parts during installation.
2. Install front ABS sensor on strut and wheel apron bracket.
3. Place a thickness gauge between ABS sensor's and tone wheel's tooth face. After standard clearance is obtained over the entire perimeter, tighten
ABS sensor on housing to specified torture.
CAUTION: Check the marks on the harness to make sure that an distortion exists.
NOTE: If the clearance is outside specifications, readjust.
4. After confirmation of the ABS sensor clearance, connect connector to ABS sensor.
5. Connect connector to battery ground cable.