Legacy Outback Ltd Sedan AWD F4-2.5L SOHC (2001)
2. Loosen nut and remove rear bushing.
ASSEMBLY
Front Bushing
To reassemble, reverse disassembly procedures.
CAUTION: Install front bushing in correct direction, as shown in figure.
Rear Bushing
1. Install rear bushing to transverse link and align aligning marks scribed on the two.
2. Tighten self-locking nut.
CAUTION:
^
Discard loosened self-locking nut and replace with a new one.
^
While holding rear bushing so as not to change position of aligning marks, tighten self-locking nut.
Tightening torque: 186 Nm (19.0 kgf-cm, 137 ft. lbs.)
INSPECTION
1. Check transverse link for wear, damage and cracks, and correct or replace if defective.
2. Check bushings for cracks, fatigue or damage.
3. Check rear bushing for oil leaks.