Legacy Outback VDC Wagon AWD F6-3.0L (2001)
Impact Sensor: Service and Repair
Removal and Installation
Side Airbag Sensor
REMOVAL
1. Turn ignition switch OFF.
2. Disconnect the ground cable from the battery, and wait for at least 20 seconds before starting work.
3. Remove center pillar lower trim. <Ref. to REMOVAL, Lower Inner Trim.>
4. Remove Outer Belt (FRONT). <Ref. to REMOVAL, Front Seat Belt.>
5. Remove bracket (A), and then remove cap (B).
6. Using E12 TORX(R) remove two TORX(R) nuts, and then detach side airbag sensor (A).
INSTALLATION
CAUTION: Use new TORX(R) nuts during re-assembly.
Install in the reverse order of removal.
Front Sub Sensor
REMOVAL
1. Turn ignition switch OFF.
2. Disconnect the ground cable from the battery, and wait for at least 20 seconds before starting work.
3. Remove front bumper.