Legacy Outback VDC Wagon AWD F6-3.0L (2001)
8. Using ST1 and ST2, press sub seal into place.
9. Apply sufficient grease to oil seal lip. Specified grease: SHELL 6459N
CAUTION:
^
Do not apply pressure more than 3.92 kN (0.4 ton, 0.4 US ton, 0.4 Imp ton).
^
If specified grease is not available, remove bearing grease and apply Auto Rex A instead.
^
Do not mix different types of grease.
10. Install back plate to rear housing. Tightening torque:52 ± 6 Nm (38.3 ± 4.3 ft. lbs.).
11. Using ST1 and ST2, press bearing into hub.
ST1 927080000 HUB STAND
ST2 927450000 HUB INSTALLER
CAUTION: Do not apply pressure more than 25 kN (2.5 ton, 2.3 US ton, 2.5 Imp ton).
INSPECTION
1. Inspect the rattle of bearing, give the tires a shake with grasping both the upper and lower sides of the tire. And also inspect to rotate the wheel
smoothly.
2. The lean of axis direction: Limit: Maximum 0.05mm (0.0020 in).
3. Inspect the removed parts for wear and damage. If defective replace with new ones.
CAUTION: If bearing is faulty, replace it as the bearing set. Be sure to replace oil seal at every overhaul.
4. Install knuckle.