Legacy Outback VDC Wagon AWD F6-3.0L (2001)
7. Disconnect cable from select lever and then remove cable bracket.
8. Remove select cable from plate assembly.
B: INSTALLATION
1. Install select cable to plate assembly.
Tightening torque: 32 Nm (3.3 kgf-m, 24 ft. lbs.)
2. Install select cable to range select lever.
3. Install plate assembly to transmission.
Tightening torque:
T: 24.5 Nm (2.5 kgf-m, 18.1 ft. lbs.)
4. Install snap pin to range select lever.
5. Move the select lever to the "N" position, then adjust the select cable position.