Legacy Outback VDC Wagon AWD F6-3.0L (2001)
Transmission Speed Sensor: Service and Repair
A: REMOVAL
1. Disconnect battery ground cable.
2. Disconnect transmission connector.
3. Remove the transmission connector from stay.
4. Lift-up the vehicle.
5. Clean transmission exterior.
6. Drain ATF completely.
NOTE: Tighten ATF drain plug after draining ATF.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
7. Remove front, center, exhaust pipes and muffler.
8. Remove the shield cover.
9. Remove the propeller shaft.