Legacy Outback VDC Wagon AWD F6-3.0L (2001)
![background image](/subaru/legacy_outback_vdc_wagon_awd/f6-3.0l/Page-858001.png)
Valve Body: Service and Repair
A: REMOVAL
1. Clean transmission exterior.
2. Drain ATF completely.
NOTE: Tighten ATF drain plug after draining ATF.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
3. Remove the oil pan.
NOTE:
^
Remove and clean the magnet.
^
Remove the old gasket on the oil pan and transmission case completely.
4. Disconnect duty solenoids and ATF temperature sensor connectors. Remove connectors from clip and disconnect connectors at 9 places.
5. Remove the control valve.