Legacy Outback VDC Wagon AWD F6-3.0L (2001)
5. Using flat bladed screwdriver, remove snap ring.
6. Using ST1, support housing securely.
7. Using ST2, press inner race to drive out outer bearing.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING REMOVER
CAUTION:
^
Do not remove outer race unless it is faulty.
^
Discard outer race after removal.
^
Do not replace inner or outer race separately; always replace as a unit.
8. Using ST and a hydraulic press, drive hub bolts out. ST 927080000 HUB STAND
CAUTION: Be careful not to hammer hub bolts. This may deform hub.
D: ASSEMBLY
1. Attach hub to ST securely.
ST 927080000 HUB STAND
2. Using a hydraulic press, press new hub bolts into place.
CAUTION: Be sure to press hub bolts until their seating surfaces contact the hub.