Legacy Outback Wagon F4-2.5L SOHC (2000)
Cruise Control Switch: Description and Operation
Command Switch
-
When the vehicle Is in the cruise control mode, the command switch controls its operation. If input SET/COAST signal, ACCEL/RESUME signal
or CANCEL signal to the cruise control module.
-
The command switch is located on the right side of the steering wheel and can be operated without releasing your hand from the steering wheel.
-
The command switch is an auto return lever type.
1. RESUME/ACCEL AND SET/COAST SWITCH
The switch is caused to be ON as long as the lever is kept pressed in any of the positions, and outputs it as a signal to the control module.
2. CANCEL SWITCH
The switch is caused to be ON as long as the lever is pulled toward CANCEL (toward you), and outputs RESUME/ACCEL and SET/COAST
ON signals simultaneously.