Removal and Installation of Intake Manifold
Intake Manifold: Service and Repair
Disassembly and Assembly
INTAKE MANIFOLD
DISASSEMBLY
2200 cc MODEL
1) Disconnect engine ground terminal from intake manifold.
2) Disconnect EGR vacuum hose from EGR valve. (AT vehicles)
3) Disconnect back pressure hose from pipe (AT vehicles)
4) Disconnect BPT hoses from EGR solenoid valve and intake manifold. (AT vehicles)
5) Remove BPT with BTP holder bracket. (AT vehicles)
6) Remove EGR valve. (AT vehicles)
7) Disconnect connectors from throttle position sensor, ignition coil, fuel injectors, idle air control solenoid valve, purge control solenoid valve
and EGR solenoid valve. (AT vehicles)
A) EGR solenoid valve (AT vehicles)
B) Throttle position sensor
C) Idle air control solenoid valve
D) Purge control solenoid valve
8) Remove engine harness from intake manifold.