Legacy Sedan 2WD F4-2.2L SOHC (1990)
Lifter / Lash Adjuster: Customer Interest
Hydraulic Lash Adjusters - Noisy
NUMBER 02-68-89
DATE
05-17-89
1990 LEGACY 2.2 LITER ENGINE
SUBJECT:
LEGACY HLA NOISE
Should you encounter a Legacy engine with noisy hydraulic lash adjusters (R7A) which do not pressurize during normal running, the cause may be a
partially blocked oil passage in the rocker shaft.
Procedure for cleaning rocker shaft:
(1)
Remove and disassemble the valve rocker shaft assembly from which you suspect the noise is coming in accordance with the Legacy Service
Manual, chapter 2-3, W3A0 through W3E0.
(2)
Check the rocker shaft for foreign matter in the oil holes; for example, a tiny pliable piece of liquid gasket. Clean all holes and passages
thoroughly.
(3)
Make sure to bleed the HLA of air in accordance with the Legacy Service Manual, chapter 2-3, W3C1.
(4)
Reassemble the engine, run and check it for noise.
This procedure can be claimed under warranty using operation number:
B 243-043
0.6
one side
R&R
or
B 243-044
1.1
both sides
R&R
plus
C 243-046
0.3
for overhaul each side