Legacy Sedan 2WD F4-2.2L SOHC (1990)
DOHC CYLINDER BLOCK
1. Install ST to cylinder block, then install crankshaft bearings. ST 499817000 ENGINE STAND.
CAUTION: Remove oil the mating surface of bearing and cylinder block before installation. Also apply a coat of engine oil to crankshaft pins.
2. Position crankshaft on the # 2 and # 4 cylinder block.
Tightening torque:
T1: 25 + 2 N.m (2.5 + 0.2 kg-m, 18.1 + 1.4 ft-lb).
T2: 47 + 3 N.m (4.8 + 0.3 kg-m, 34.7 + 2.2 ft-lb).
INSTALLATION
3. Apply fluid packing to the mating surface of # 1 and # 3 cylinder block, and position it on # 2 and # 4 cylinder block. Fluid packing: THREE
BOND 1215 or equivalent
CAUTION: Do not allow fluid packing to jut into 0-ring grooves, oil passages, bearing grooves, etc.