Legacy Sedan 2WD F4-2.2L SOHC (1990)
2. Check harness connector between ECU and vehicle speed sensor.
a) Remove connector from ECU and combination meter.
b) Measure resistance between ECU connector and combination meter connector.
(Connector) Terminal/Specified resistance:
(B58) No.11 - (i13) No.1/0 Ohms
c) Measure resistance between combination meter connector and body.
(Connector) Terminal/Specified resistance:
(i13) No.1 - Body/1M Ohm min.
(i16) No.7 - body/ 0 Ohm
3. Check vehicle speed sensor.
a) Remove combination meter.
b) Insert a screwdriver into portion occupied by meter cable and rotate rotor.
c) Check that voltage across combination meter terminals deflects between 0 and 5 volts four times per gear rotation.
(Connector) Terminal/Specified voltage:
(i13) No.1 - (i16) No.7/0 <-> 5 Volts
SELECT MONITOR FUNCTION MODE - Mode: 03
Condition: While driving vehicle
Specified data: VSP F02 (Car speed) km/h