Legacy Sedan 2WD F4-2.2L SOHC (1990)
Continuously Variable Transmission/Transaxle: Technical Service Bulletins
A/T - Case Check Balls Leaking ATF
NUMBER:
03-44-89
DATE:
09-20-89
ALL AUTOMATIC TRANSMISSION MODELS
SUBJECT:
TRANSMISSION CASE CHECK BALLS LEAKING ATF
If a condition should occur where the cheek balls on the exterior of the transmission case are leaking ATF, please follow the repair procedures listed
below:
1.
With the vehicle on the lift, clean off transmission case with brake cleaner. Run engine with transmission in gear to locate the leaking cheek
ball.
2.
Using a drift punch or pin punch (of adequate diameter), seat the check ball approximately 1 mm deeper into the hole measured from the
outer surface of the case.
3.
Thoroughly clean surface free of oil or dirt.
4.
Apply an epoxy type metal bond (i.e., Devcon or Permatex) to the affected area filling the hole. Let dry for a minimum of 12 hours without
operating the vehicle.
This procedure can be claimed for vehicles within the terms of the limited Subaru warranty, using the following:
Failure code MJV-34
Transmission in car service:
Reseal check ball Operation number A333-821 / 0.4 hrs.
Transmission out of car service:
Reseal cheek ball 3 speed A/T
Operation number
B343-001 (R&R trans)
2.6
(4wd add)
0.2
C343-821 reseal plug
0.3
Transmission out of car service:
Reseal check ball 4EAT Trans.
LOYALE
LEGACY
Operation number
B393-001 (R&R trans)
2.2
2.7
(4wd add)
0.2
0.2
C393-821 reseal plug
0.3
0.3