Legacy Sedan 4WD F4-2.2L SOHC (1992)
INSTALLATION
1. Install ENGINE STAND to cylinder block, then install crankshaft bearings. Remove oil from the mating surface of bearing and cylinder block
before installation. Also apply a coat of engine oil to crankshaft pins.
2. Position crankshaft on the # 2 & # 4 cylinder block.
3. Apply fluid packing to the mating surface of # 1 & # 3 cylinder block, and position it on # 2 & # 4 cylinder block. Fluid packing: Three-bond
1215 or equivalent.
Do not allow fluid packing to jut into 0-ring grooves, oil passages, bearing grooves, etc.
4. Temporarily tighten # 1 & # 3 cylinder block side connecting bolts to 20 to 29 N.m (2 to 3 kg-m, 14 to 22 ft-lb).
5. Turn cylinder block so that it is horizontal. Tighten all cylinder block connecting bolts to specified torque, starting with bolts on the # 1 & # 3
cylinder block side.