Legacy Sedan 4WD F4-2.2L SOHC (1992)
Clutch Release Bearing: Service and Repair
Installation
INSTALLATION
CAUTION: Before or during assembly, lubricate the following points with a light coat of grease.
-
Inner groove of release bearing
-
Contact surface of lever and pivot
-
Contact surface of lever and bearing
-
Transmission main shaft spline (Use grease containing molybdenum disulfide.)
1. MECHANICAL APPLICATION TYPE
1) While pushing release lever (3) to pivot and twisting it to both sides, tit retainer spring (5) onto the constricted portion of pivot.
NOTE: Confirm that retainer spring is securely fitted by observing it through the main case hole.
2) Install release bearing (6) and fasten it with two clips (2).
3) Install release lever seal (4).
4) After remounting engine and transmission on body, make adjustment of the clutch release lever end play.
CAUTION: Take care not to twist the cable during adjustment.
5) Install release lever return spring (Models without hill holder only).
NOTE: Hook up the return spring to right side hole of the release lever.