Legacy Sedan 4WD F4-2.2L SOHC (1992)
15. Remove bolts which secure rear housing to strut and separate.
Caution: Be careful not to damage oil seal lip when removing rear drive shaft. Always replace inner oil seal with a new one.
Installation
1. Connect rear housing assembly and strut assembly, torque mount bolts to 132 - 162 Nm (98 - 119 ft.lbs).
2. On ABS equipped vehicles, install rear speed sensor to back plate.
3. Fit BJ (Bell Joint) to rear housing splines taking care not to damage the inner oil seal lip.