Legacy Sport Utility LTD AWD F4-2.5L DOHC (1999)
Standard: L
144.6 mm (0.5693 inch)
If it is not in specified value, adjust it by adjusting brake booster operating rod.
8. Measure the clearance between threaded end of stop light switch and stopper.
If it is not in specified value, adjust it by adjusting position of stop light switch.
1. Stop light switch.
2. Stopper.
3. Brake pedal.
CAUTION: Be careful not to rotate stop light switch.
Stop light switch clearance: A
0.3 mm (0.012 inch)
9. Apply grease to operating rod connecting pin to prevent it from wearing.
10. Bleed air from brake system.
Tightening torque (Air bleeder screw): 8 ± 1 Nm (0.8 ± 0.1 kg-m, 5.8 ± 0.7 ft. lbs.)
11. Conduct road tests to ensure brakes do not drag.
C: OPERATION CHECK
CAUTION: When checking operation, be sure to securely apply the hand brake.
1. Checking Without Using Gauges
This method cannot determine the exact portion which has failed, but it can provide a rough understanding of the nature of the failure if checking
is conducted in accordance with the following procedures.
2. Air Tightness Check
Start engine, and run it for 1 to 2 minutes, then turn it off. Depress brake pedal several times applying the same pedal force as that used in ordinary
braking operations. The pedal stroke should be greatest on the 1st depression, and it should become smaller with each successive depression. If no