Legacy Sport Utility LTD AWD F4-2.5L DOHC (1999)
D: INSPECTION
Perform the inspection procedures and repair or replace defective parts.
E: ASSEMBLY
1. Reassembly precautions
(1) Whenever O-rings, oil seals, and snap rings are removed, they must be replaced with new ones.
(2) Thoroughly wash parts and allow to dry. They must be kept free from cleaning oil and dust.
(3) Reassembly procedure must be performed in clean place. Ensure that parts are kept away from waste threads or other dust particles.
(4) Cleaning oil tends to stay inside the front casing. Remove it completely by blowing compressed air.
(5) Ensure that parts are free from rust. (Use specified hydraulic oil for rust prevention after cleaning and drying.)
(6) Reverse the sequence of disassembly procedures.
2. Shaft
(1) Apply grease to oil seal and inner surface of front casing (at bearing location).
CAUTION: Make sure that the front body internal surfaces are free from damage.
(2) Using ST, press-fit oil seal into front body.
ST 340099AA000 Installer
CAUTION: When press-fitting, use care to prevent damage to surface mating with rear body.
NOTE: Orient oil seal toward correct direction.
(3) Using ST, press-fit shaft assembly into front body and mount snap ring.
ST 340099AA020 Installer
NOTE: Turn snap ring to ensure that it fits right into the groove.
3. Cartridge assembly