Legacy Sport Utility LTD AWD F4-2.5L DOHC (1999)
Insert a round rod [26 - 27 mm (1.02 - 1.06 inch) dia.] from pinion housing side and remove oil seal and back-up washer by hammering the rod.
NOTE:
-
Discard removed oil seal and back-up washer.
-
Apply the unchamfered end of remover to back-up washer.
Installation
Force-fit oil seal and back-up washer using ST.
ST 927650000 Installer
CAUTION: Be careful not to damage or scratch cylinder inner wall.
NOTE:
-
Apply ATE DEXRON II to oil seal.
-
Pay special attention not to install back-up washer and oil seal in wrong direction.
-
Push oil seal until the stepped portion of A contacts end face of B.
D: ASSEMBLY
1. Rack Assembly
1) Fixing rack housing Fix rack housing in vice using ST.
ST 926200000 Stand
CAUTION:
-
When fixing rack housing in vice, be sure to use this special tool. Do not fix rack housing in vice using pad such as aluminum plates, etc.
-
When using old rack housing, be sure to clean and remove rust before assembling. Check pinion housing bushing carefully.