Legacy Wagon 4WD F4-2.5L DOHC (1996)
Electronic Brake Control Module: Service and Repair
ABS/TCS Control Module
Removal
REMOVAL
1) Disconnect ground cable from battery.
2) Remove floor mat located under lower right side of front seat.
3) Remove screw which secure ABS/TCS control module from the body.
4) Disconnect connector from ABS/TCS control module.
Inspection
INSPECTION
Check that connector is connected correctly and that connector terminal sliding resistance is correct.
Installation
INSTALLATION
1) Connect connector to ABS/TCS control module.
2) Install ABS/TCS control module on the body.
CAUTION:
-
When installing seat rail, be careful no to have the harness caught in the rail.
-
Cover the connector completely with rubber boot.