Legacy Wagon 4WD F4-2.5L DOHC (1996)
Brake Lamp: Service and Repair
Removal and Installation
Stop and Tail Light
1. REAR COMBINATION LIGHT
1. Remove rear trim.
2. Disconnect connector from rear combination light.
3. Remove nuts which secure rear combination light.
Tightening torque:
2.5 ± 0.5 N.m (0.25 ± 0.05 kg-m, 1.8 ± 0.4 ft-lb)
4. Attach adhesive cloth tape to body area around rear combination light.
5. Using a standard screwdriver, carefully pry rear combination light off and away from the vehicle.
CAUTION:
-
Do not pry rear combination light forcefully as this may scratch vehicle body.
-
Remove all traces of adhesive tape from body before installation.
-
Attach butyl rubber tape to back of rear combination light before installing rear combination light on body for sealing purposes.
2. REAR FINISHER