Legacy Wagon 4WD F4-2.5L DOHC (1996)
4.
Using only your fingers, turn the fuel injector(s) 90 degrees. The fuel injector(s) connectors on both sides of the engine should be pointed towards
the front of the vehicle. Refer to Figure 2.
5.
Using a large flat screwdriver with a 3/8 to 1/2 inch blade gently pry the injector up by twisting the screw driver between the underside of the fuel
injector connector area and the fuel injector cap mounting area. Refer to Figure 3. NOTE: Do not damage the fuel injector cap mounting threads.
6.
Remove the fuel injector(s) and place it in the box that contained the new injector(s) or wrap it to protect it during return shipping and handling.
Any injectors received damaged will not be accepted.
FUEL INJECTOR INSTALLATION
1.
Coat the fuel injector "O" ring(s) of the new injector(s) and the mating area of the fuel rail with engine oil. Install the fuel injector(s) into the fuel
rail and carefully push it in by hand until it is fully seated. Make sure the injector connector is in the correct position so the injector cap can be
installed correctly.
2.
Place the rubber spacer(s) back in position and install the injector cap and bolts.
3.
Reconnect the fuel pump connector.
4.
Reinstall the air cleaner case, air flow meter, air inlet boot and tie-wrap for SVX vehicles that was previously removed.
5.
Start the engine while holding the accelerator open 1/4 throttle to clear any fuel that may have dripped into the intake manifold.
6.
Carefully check each injector for leaks.