Legacy Wagon 4WD F4-2.5L DOHC (1996)
CAUTION:
-
Do not reuse removed snap ring.
-
Be careful not to scratch pinion and valve assembly.
2) Press out bearing together with backing washer using pipe of I.D. 38.5 to 39.5 mm (1.516 to 1.555 in) and press.
CAUTION: Do not reuse removed bearing.
3) Remove oil seal.
CAUTION: Do not reuse removed oil seal.
-
Installation
1) Fit pinion and valve assembly into valve housing.
NOTE: Apply ATF DEXRON II to outer diameter surface of input shaft and outer surface of valve body seal ring, and pay special attention
not to damage seal when inserting pinion and valve assembly.
2) Secure valve assembly to ST1 and ST2.
3) Put ST3 over pinion, and insert oil seal, then force-fit oil seal into housing using ST4.
NOTE:
-
Apply ATF DEXRON II to oil seal and ST3, being careful not to damage oil seal lip.
-
Push oil seal until ST3 contacts housing end face.