Legacy Wagon 4WD F4-2.5L DOHC (1996)
Drive/Propeller Shaft: Service and Repair
C: Disassembly
C: DISASSEMBLY
Before removing center bearing, check its condition. If it does not operate smoothly or if there is any free play or leakage, remove as follows:
1) Put matching marks on affected parts.
2) Remove bolts which hold front propeller shaft to rear propeller shaft.
3) Place companion flange in a vise and remove stake nut.
CAUTION: Be sure not to hold propeller shaft pipe portion in the vise.
4) Drive out companion flange with a puller or press.
NOTE: Before disassembling, put matching mark on affected parts.