Legacy Wagon 4WD F4-2.5L DOHC (1996)
9) Remove disc rotor from hub.
If disc rotor seizes up within hub, drive disc rotor out by installing an 8-mm bolt in screw hole on the rotor.
10) Remove cotter pin and castle nut which secure tie-rod end to housing knuckle arm.
11) Using a puller, remove tie-rod ball joint from knuckle arm.
12) On ABS. equipped models, remove A.B.S. sensor assembly and harness in advance.
CAUTION: Be sure to use soft laws (such as aluminum plates) when placing the mating surfaces of housing and strut in a vise.