Legacy Wagon 4WD F4-2.5L DOHC (1996)
1) Using ST1 and ST2, remove hub from rear housing.
ST1 927080000 HUB STAND
ST2 927420000 HUB REMOVER
2) Remove back plate from rear housing.
3) Using a standard screwdriver, remove outer and inner oil seals.
CAUTION: Use new oil seals.
4) Using flat bladed screwdriver, remove snap ring.
5) Using ST1 and ST2, remove bearing by pressing inner race.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER
CAUTION:
-
Do not remove bearing unless damaged.
-
Do not re-use bearing after removal.
6) Remove tone wheel bolts and remove tone wheel from hub (only vehicle equipped with A.B.S.).
7) Using ST, press hub bolts out. ST 927080000 HUB STAND