Loyale Wagon 2WD F4-1781cc 1.8L SOHC Turbo (1990)
Wheel Bearing: Adjustments
ADJUSTING REAR WHEEL BEARING
Seating Bearing
1) Temporarily tighten axle nut with tightening torque of 49 Nm (5 kg-m, 36 ft-lb), and then turn drum back and forth alternately several times to
properly seat bearing and determine bearing stability.
Starting Force Measurement
2) Turn back nut 1/8 to 1/10 in order to obtain correct starting torque. Measure the starting force as shown.
Starting force when measured at hub bolt:
8.34-14.22 N (0.85-1.45 kg, 1.87-3.20 lb).
Note: Make sure there is no free play in the bearing.
3) Bend lock washer.
Cap To Drum
4) After installing 0-ring to drum cap, install cap to brake drum by lightly tapping with plastic hammer.
Note:
a. Do not use steel hammer etc..
b. Be sure to use new O-ring