Outback F4-2.5L (2008)
16) Install the roll connector to combination switch and bind the harness with vinyl tape as originally bound.
17) Install the paddle shift. (Model with paddle shift)
18) Install the steering wheel.
Tightening torque: 44 N-m (4.5 kgf-m, 32.5 ft-lb)
19) Install the airbag module to the steering wheel.
WARNING: Always refer to "Airbag System" before performing the service operation.
20) Connect the ground cable to the battery.
CAUTION:
^
After completion of installation, adjust the following two positions.
^
Positioning to the center of steering angle sensor
^
Positioning the yaw rate & lateral G sensors to zero.
The above procedure is required for the VDCCM to identify vehicle position afterward. For the setting procedures of the 2 steps above, refer to "VDC
Control Module and Hydraulic Control Unit (VDCCM & H/U)".
