Outback F4-2.5L (2008)
Parking Brake Cable: Service and Repair
Parking Brake Cable
REMOVAL
1) Remove the rear seat cushion.
2) Remove the console box.
3) Remove the parking cable adjusting nut (selflocking nut).
4) Remove the parking brake lever.
5) Roll up the floor mat and remove the clamps.
6) Remove the inner cable end from equalizer.
7) Lift up the vehicle, and then remove the rear wheels.
8) Remove the parking brake cable from rear brake.
9) Remove the clamp from the rear brake.
10) Remove the cable clamp from the rear arm bracket.
11) Remove the cable clamp from rear floor.
12) Remove the cable assembly.
INSTALLATION
1) install in the reverse order of removal.
NOTE: Be sure to pass the cable through the tunnel in the cable guide.
2) Be sure to adjust the lever stroke.
INSPECTION