Outback F4-2.5L (2008)
Lateral Accelerometer: Service and Repair
With VDC
Yaw Rate and Lateral G Sensor
REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the console box.
3) Disconnect the connector from yaw rate & lateral G sensor.
4) Remove the yaw rate & lateral G sensor.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 7.5 N-m (0.76 kgf-m, 5.5 ft-lb)
CAUTION:
^
After completion of installation, set the following two positions.
^
Positioning to the center of steering angle sensor
^
Positioning the yaw rate & lateral G sensors to zero. The above procedure is required VDCCM & H/U to identify the vehicle position
afterward. For the setting procedures of the 2 steps above, refer to "VDC Control Module and Hydraulic Control Unit (VDCCM &
H/U)".
INSPECTION
YAW RATE & LATERAL G SENSOR
