Outback F4-2.5L (2008)
5) Install the cam sprocket (LH) using ST.
6) Install the belt idler No. 2.
7) Install an automatic belt tension adjuster with the tension rod held by a pin.
8) Install the timing belt.
9) Install the crank pulley.
10) Install the V-belts.
11) Install the radiator.
INSPECTION
1) Check the water pump bearing for smooth rotation.
2) Check the water pump pulley for abnormalities.
3) Make sure the impeller is not deformed or damaged.
4) Inspect the clearance between impeller and pump case.
Clearance between impeller and pump case:
Standard 0.5 - 1.5 mm (0.020 - 0.060 in)
5) After water pump installation, check pulley shaft for engine coolant leaks. If leaks are noted, replace the water pump assembly.