Outback F4-2.5L (2008)
CAUTION: If brake fluid is spilled on the vehicle body, wash it off immediately with water and wipe clean.
7) Remove the nuts and remove the ABSCM & H/U.
CAUTION:
^
Do not drop or bump the ABSCM & H/U.
^
Do not turn the ABSCM & H/U upside down or place it sideways for storage.
^
Be careful not to let foreign matter enter into ABSCM & H/U.
^
Be careful that no water enters the connectors.
8) Remove the ABSCM & H/U bracket.
INSTALLATION
1) Install the ABSCM & H/U bracket.
Tightening torque: 33 N-m (3.3 kgf-m, 24 ft-lb)
2) Align the damper groove of the ABSCM & H/U to the bracket side claw, and install the ABSCM & H/U with new nuts (Part No. 023506000).
NOTE: Check the identification marks of the ABSCM & H/U.
3) Connect the brake pipes to their correct ABSCM & H/U positions.
Tightening torque: 15 N-m (1.5 kgf-m, 10.8 ft-lb)
4) Using a harness clip, secure the ABSCM & H/U harness to the bracket.
5) Connect the connector to the ABSCM & H/U.
NOTE:
^
Be sure to remove all foreign matter from inside the connector before connecting.
^
Make sure the ABSCM & H/U connector is securely locked.
6) Bleed air from the brake system.
INSPECTION
1) Check the condition of connection and settlement of connector.
2) Check the mark used for ABSCM & H/U identification.