subaru Workshop Repair Guides

Subaru Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 1
background image

Ignition Control Module: Service and Repair

Ignition Coil And Ignitor Assembly

REMOVAL

1. Disconnect the ground cable from the battery.

2. Disconnect the spark plug cords from ignition coil and ignitor assembly.

3. Disconnect the connector from the ignition coil & ignitor assembly.
4. Remove the bolt which secures the ignition coil and ignitor assembly to the intake manifold.

INSTALLATION

Install in the reverse order of removal.

Tightening torque: 8 N.m (0.8 kgf.m, 5.9 ft.lb)

CAUTION:  Connect the spark plug cords to correct positions. Failure to do so will damage the unit.

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Diagrams > Page 221

< PREV PAGE NEXT PAGE >