Outback F4-2.5L (2008)
2) Install the air intake chamber and intake boot. (Non-turbo model)
3) Install the intercooler. (Turbo model)
4) Connect the battery ground cable to the battery.
CROSSMEMBER AND CUSHION RUBBER
1) Install the transmission cushion rubber.
Tightening torque: 35 N-m (3.6 kgf-m, 25.8 ft-lb)
2) Install the front crossmember and rear cross-member.
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5) Install the front and center exhaust pipe. (Non-turbo model)
6) Install the center exhaust pipe. (Turbo model)
7) Install the rear exhaust pipe and muffler.
^
Non-turbo model
^
Turbo model
8) Lower the vehicle.
9) Connect the battery ground cable to the battery.