Outback F4-2.5L (2008)
-
Do not tightly pull the piano wire against the windshield glass edge.
-
Be careful not to damage interior and exterior parts.
-
When removal is made with area close to instrument panel, place a protection plate over it. Pay particular attention to the removal.
-
Do not cross piano wires. Otherwise they may be cut.
INSTALLATION
1. Clean the external circumference of windshield glass with alcohol or white gasoline.
2. Remove the adhesive layer on the body using cutter knife to obtain smooth face of 2 mm (0.08 in) thick.
CAUTION: Be careful not to damage the body and paint surface.
3. Clean the body with alcohol or white gasoline to eliminate cutting powder, dust and dirt completely from body.
4. Install the dam rubber.
5. Fit the mark (B) on molding to the notch (A) of glass side, and install the molding to entire perimeter of glass.
