Outback F4-2.5L DOHC Turbo (2006)
5. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
6. On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
7. On the "System Selection Menu" display screen, select the {Occupant Sensing System} and press the [YES] key.
8. Press the [YES] key after the {Occupant Sensing System} is displayed.
9. On the "Occupant Sensing System" display screen, select the {DTC Display} and press the [YES] key.
NOTE:
-
For details concerning operation procedure, refer to "SUBARU SELECT MONITOR OPERATION MANUAL".
-
For details concerning DTCs, refer to the "List of Diagnostic Trouble Code (DTC)". See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions/Manufacturer Code Descriptions/Occupant Detection System -
Diagnostics
-
Display all the DTCs detected.
-
If a particular DTC is not properly stored in memory (due to a drop in occupant detection control module power supply, etc.) on the
occurrence of a problem, the DTC which is suffixed with a question mark appears on the Subaru Select Monitor display. This shows it may
be an unreliable reading.
10. If the occupant detection control module cannot communicate with Subaru Select Monitor, check the communication circuit. See: Initial
Inspection and Diagnostic Overview/Initial Inspection
11. When DTC is not displayed, check the meter circuit or select monitor communication circuit. See: Initial Inspection and Diagnostic
Overview/Initial Inspection
2. SENSOR DATA OUTPUT
1. On the «Occupant Sensing System» main menu display screen, select the {Sensor Data Output} and press the [YES] key.
NOTE: Do not touch the vehicle within 20 seconds after pressing the [YES] key. Output value may be changed when sensing the pitching
and vibration of the vehicle while reading sensor data output.
2. Sensor output will be displayed in the (*****).
Press the [YES] key to move to the main menu.
3. CLEAR MEMORY MODE
1. Select the {Occupant Sensing System} from the main menu, and press the [YES] key.
2. On the "Occupant Sensing System" display. screen, select the {Clear Memory} and press the [YES] key.
3. When the {Done} is shown on the display, DTCs will be erased.
NOTE: When the {Cannot erase the DTC stored, perform the diagnosis according to trouble symptom} is shown, read the DTC and perform
the diagnosis according to DTC.