subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

SRS - Seat Belt Warning Chime With Nobody in Pass. Seat|Page 6420 > < SRS - Seat Belt Warning Chime With Nobody in Pass. Seat|Page 6414
Page 1
background image

Seat Latch: Customer Interest
SRS - Seat Belt Warning Chime With Nobody in Pass. Seat

NUMBER: 17-10-05 
DATE: 10/06/05

APPLICABILITY: 
2005MY Legacy and Outback

SUBJECT:
ODS (Occupant Detection System) Front Passenger Seatbelt Warning Chime

INTRODUCTION

If you encounter a customer complaint that the front passenger seat belt warning chime sounds with no one sitting in the seat, there is the possibility that
the hinge spring needs to be replaced.

PRODUCTION LINE CHANGE

The new style spring was used in production starting in August, 2004 with the VINs shown.

PART INFORMATION

Note:

Make sure to use the correct kit based on the interior color.

REPAIR PROCEDURE/INFORMATION

Refer to the STIS web site for the applicable Subaru Service Manual for diagnostics and troubleshooting; if nothing is found proceed with the following
repair procedure.

1)

Measure each seat position sensor output data using the SSMII (Subaru Select Monitor) and record the values; refer to the Subaru Service Manual,
Body Section 8, Occupant Detection System (Diagnostics) OD (diag), Subaru Select Monitor.

Note

When measuring make sure the following criteria is met:

^

Ambient temperature is between 32° F to 104° F.

^

Vehicle is parked on level surface.

^

Seat slide position is all the way back and slide rail is securely locked.

^

Seat backrest is fully upright and redining position is securely locked.

SRS - Seat Belt Warning Chime With Nobody in Pass. Seat|Page 6420 > < SRS - Seat Belt Warning Chime With Nobody in Pass. Seat|Page 6414