Outback F4-2.5L SOHC (2005)
Electronic Brake Control Module: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect the ground cable from battery.
2. Use compressed air to get rid of water and dust around the ABSCM&H/U.
NOTE: When dust and dirt are attached to the terminal, they may cause poor contact.
3. Disconnect the ABSCM&H/U connector pulling up the lock lever.
CAUTION: Do not pull the harness when disconnecting connector.
4. Remove the harness clip.
5. Disconnect the brake pipes from ABSCM&H/U.
6. Wrap the brake pipe using a vinyl bag not to spill the brake fluid on the vehicle body.
CAUTION: When brake fluid is attached to the vehicle body, wash it off with water and wipe the water.
7. Remove the nuts and remove the ABSCM&H/U.
CAUTION:
^
Do not drop or bump the ABSCM&H/U.
^
Do not turn ABSCM&H/U upside down or place it sideways for storage.
^
Be careful that no foreign objects are mixed in ABSCM&H/U.
^
Be careful that no water enters inside the connectors.
8. Remove the ABSCM&H/U bracket.
INSTALLATION
1. Install the ABSCM&H/U bracket.
Tightening torque: 33 Nm (3.3 kgf-m, 24 ft. lbs.)