Outback F4-2.5L SOHC (2005)
Wheel Speed Sensor: Service and Repair
Front Magnetic Encoder
REMOVAL
Refer to "Front Hub Bearing" for removal, because the front magnetic encoder is integrated with front hub bearing.
INSTALLATION
Refer to "Front Hub Bearing" for installation, because the front magnetic encoder is integrated with front hub bearing.
INSPECTION
Visually check the magnetic encoder for any damage. If necessary, replace with a new hub unit bearing.
NOTE: Replace the hub unit bearing with a new one if there is any defect found on the magnetic encoder, since the magnetic encoder is integrated
with hub unit bearing assembly.