Outback F4-2.5L SOHC (2005)
2. Install the ABSCM&H/U aligning the groove of damper on ABSCM&H/U side with the pawl of bracket.
NOTE: Check the identification mark of ABSCM&H/U.
3. Connect the brake pipes to their correct ABSCM&H/U positions.
Tightening torque: 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
4. Using a harness clip, secure the ABSCM&H/U harness to bracket.
5. Connect the connector to ABSCM&H/U.
NOTE:
^
Be sure to remove all foreign matters from inside the connector before connecting.
^
Ensure the ABSCM&H/U connector is securely locked.
6. Bleed air from the brake system.