Outback F4-2.5L SOHC (2005)
Crankshaft Main Bearing: Specifications
Torque Sequence
NOTE: Remove oil on the mating surface of bearing and cylinder block before installation. Apply a coat of engine oil to crankshaft pins.
1. Position the crankshaft on the #2 and #4 cylinder block.
2. Apply liquid gasket to the mating surface of #1 and #3 cylinder block, and position it on #2 and #4 cylinder block.
Liquid gasket: THREE BOND 1215 (Part No. 004403007) or equivalent
NOTE: Do not allow liquid gasket to flow into O-ring grooves, oil passages, bearing grooves, etc.