Outback F4-2.5L SOHC (2005)
Check List For Interview Part 2
Initial Inspection
INSPECTION
Before performing diagnostics, check the following items which might affect body integrated unit malfunctions.
1. Measure the battery voltage and check electrolyte.
Standard voltage: 12 V, or more
Specific gravity: Above 1.260
2. Check the fuse condition.
Make sure that ampere of the fuse is setting value, and it is not blown out.
3. Check the connecting condition of harness and harness connector.
4. Confirm settings of body integrated unit are corresponded to vehicle equipment.
5. Confirm setting are corresponded to vehicle equipment by function setting (ECM customizing) of body integrated unit.
6. Confirm "Factory initial setting" of body integrated unit registrations is "Market".
7. Confirm key illumination does not blink with ignition switch turned to ON.
With Manufacturer's Scan Tool
Read Diagnostic Trouble Code (DTC)
OPERATION
1. WITHOUT SUBARU SELECT MONITOR
NOTE: Use the Subaru Select Monitor, because DTCs can not be read out.
2. WITH SUBARU SELECT MONITOR
For details concerning DTC reading procedure, refer to "Subaru Select Monitor". See: Scan Tool Testing and Procedures
With Generic Scan Tool
Manufacturer does not supply instructions for displaying trouble codes With Generic Scan tool.
Without Scan Tool
Manufacturer does not supply instructions for displaying trouble codes Without Scan tool.
With Manufacturer's Scan Tool
Clear Memory Mode
OPERATION
1. WITHOUT SUBARU SELECT MONITOR
NOTE: Use the Subaru Select Monitor for Clear Memory Mode.