Outback F4-2.5L SOHC (2005)
No. 11 - 20
4. Change the setting with UP/DOWN key and press the [YES] key.
-
List of function setting item (ECM customizing)
5. After setting, make sure that vehicle equipment is same as the setting changed in the {Current Data Display & Save}.
CAUTION:
-
It is possible to control the original functions of vehicle when settings above are corresponded to vehicle equipment.
-
Do not change the settings except for setting above during operation of function setting.
-
Be sure not to change "Factory" initial setting except in installation of new body integrated unit.
NOTE: For details concerning operation procedure, refer to "SUBARU SELECT MONITOR OPERATION MANUAL".
10. FUNCTION CHECK
In order to check the body integrated unit function, inspect the body integrated unit and actuator using Subaru Select Monitor without operating
switches.
1. On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
2. On the "System Selection Menu" display screen, select the {Integ. Unit mode} and press the [YES] key.
3. On the "Integ. Unit mode failure diag" display screen, select the {System Operation Check Mode} and press the [YES] key.