Outback F4-2.5L SOHC (2005)
Engine Control Module: Service and Repair
2.5L SOHC U5/Low Emission
Engine Control Module (ECM)
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the lower inner trim of passenger's side.
3. Detach the floor mat of front passenger seat.
4. Remove the protect cover.
5. Remove the bolt and nut which hold the ECM to bracket.
6. Remove the clip (A) from bracket.
7. Disconnect the ECM connectors and take out the ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage to fuel injection system.
-
When replacing the ECM, be careful not to damage the harnesses and connectors.
Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)