Outback F4-2.5L SOHC (2005)
Dealers are also to promptly perform the applicable service procedures defined in this bulletin to correct all affected vehicles in their inventory (new,
used, demo). Additionally, whenever a vehicle subject to this service program is taken into dealer new or used inventory, or is in the dealership for
service, necessary steps should be taken to ensure the service program correction has been made before selling or releasing the vehicle.
SPECIAL TOOLS
Vehicle ECM reprogramming will require the following:
Subaru Diagnostic System (SDS)
^
SDS Toughbook
^
Subaru Select Monitor III (SSMIII Application Software)
^
Subaru Diagnostic Interface Box (SDI)
^
USB Data Link Cable and Reprogramming Cable.
Note:
If you require assistance with using the Subaru Diagnostic System (SDS), use the "Help" function icon, which will allow you access the tutorial
information.
SERVICE PROCEDURE
This service procedure will involve completing the following two (2) steps:
1) Check ECM memory for diagnostic trouble codes.
2) Reprogram ECM with updated Pack file.
1) Check ECM memory for diagnostic trouble codes.
Using the appropriate Subaru Diagnostics System (SDS) components, connect to the vehicle's
Diagnostic Link Connector (DLC) located in the vehicle¡Çs lower left dash panel.
Select the Select Monitor Icon from the SDS Graphical User Interface (GUI).
The Main Menu will appear:
1) Select Each System Check .
2) Select Engine Control System.
3) Select Diagnostic Code(s) Display.
4) Select Memorized Diagnostic Code(s).
5) Search results will appear. Proceed as follows:
If no codes are found, proceed to the "ECM Reprogramming Instructions" section of this bulletin, beginning on this page, below.
If trouble codes are found, refer to the following table for the correct repair procedure. Make any necessary repairs and clear all codes prior to
reprogramming the ECM.
2) ECM Reprogramming Instructions