Outback F4-2.5L SOHC (2005)
Use the following Pack file to reprogram the ECM:m the ECM:
STATE EMISSION TESTING ADVISORY
After ECM reprogramming, the OBD system¡Çs readiness code monitors will set to "incomplete". Normally, the vehicle needs to be driven under a
variety of conditions before the readiness code monitors will indicate "complete". (See State I/M Program Advisory Bulletin number 11-72-04, dated
8/4/04 for details.)
SERVICE PROGRAM IDENTIFICATION LABEL
Type or print the necessary information on a Service Program identification label. The completed label should be attached to the vehicle's upper radiator
support.
A quantity of labels has been sent to each dealer along with their affected VIN list. Additional labels are available through the Customer Dealer Services
Department (CDS).
CALIFORNIA "VEHICLE EMISSION RECALL - PROF OF CORECTION" CERTIFICATE
The California Air Resources Board and the Department of Motor Vehicles Registration/ Recall Program requires that all emission related
Recall/Campaign or Service Program repairs be completed before a vehicle registration is renewed. Please provide owners of vehicles registered in the
state of California a completed "Vehicle Emission Recall - Proof of Correction" certificate. Vehicle owners should be advised to retain this certificate
because the California Department of Motor Vehicles may require they provide proof this service program repair has been completed.
CLAIM REIMBURSEMENT AND ENTRY PROCEDURES
Credit to perform this Service Program will be based on the submission of properly completed repair order information. Dealers may enter the applicable
claim information through their Dealer Communications System.
If catalytic converter replacement was necessary, enter the Catalyst 1 (RH) and 2 (LH) deterioration index readings in the comments field at the time of
claim submission.
