Outback F4-2.5L SOHC (2005)
7. Remove the bolt, and then remove the shoulder anchor.
8. Remove the bolt, and then remove the adjustable anchor assembly.
9. Disconnect the pretensioner connector (A), and remove the bolt, and then remove the seat belt retractor.
NOTE: Disconnect the tension reducer connector (B) for the seat belt retractor with tension reducer function.
CAUTION:
-
Do not drop or apply any impact to the pretensioner.
-
Since the pretensioner and bracket are integrated as a unit, do not disassemble them.
2. INNER SEAT BELT ASSEMBLY
1. Turn the ignition switch to OFF, disconnect the battery ground cable from battery, and wait for more than 20 seconds before starting work.
2. Remove the four bolts in the slide rail LH and RH.
3. Disconnect the seat belt warning light connector under the seat.
4. Remove the harness clips from slide rail.
5. Remove the TORX(R) bolt, and then remove the inner seat belt assembly.