Outback F4-2.5L SOHC (2005)
Transmission Speed Sensor: Service and Repair
Front Speed Sensor
Front Vehicle Speed Sensor
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Remove the air intake chamber.
4. Disconnect the transmission connector.
5. Remove the pitching stopper.
6. Remove the transmission connector from the stay.
7. Lift-up the vehicle.
8. Clean the transmission exterior.
9. Remove the ATF drain plug to drain ATF.
CAUTION: After running the engine or after idling for a long time, the ATF is hot. Be careful not to burn yourself.
10. Tighten the ATF drain plug.
NOTE: Use a new gasket.
Tightening torque: 25 Nm (2.5 kgf-cm, 18 ft. lbs.)
11. Remove the front, center and rear exhaust pipes and muffler.
12. Remove the shield cover.
13. Remove the propeller shaft.
14. Place the transmission jack under transmission.
NOTE: Make sure that the support plates of transmission jack does not touch the oil pan.